|
YX66-394-788 Color Steel Roof Panel
YX66-394-788 Color Steel Wall Panel Installation 1. The construction equipment of the wall system adopts mobile scaffolding erected with steel pipes to lay wall panels; After the scaffold is erected, in order to prevent collapse, the scaffold shall be bound with the column or purlin, and the rest three sides shall be set with slant support to support the scaffold, forming a stable system. 2. According to the requirements of the construction drawing, use a measuring instrument to determine the position of one wall on the wall purlin and start installing one wall panel. After installing a certain number of wall panels, the levelness of the theodolite can be measured again every three wall panels. If any deviation is found in the levelness, it should be adjusted immediately; 3. Install the wall panels from west to east, check the levelness every 3 pieces, and adjust the deviation in a timely manner to prevent accumulated errors from exceeding the standard specifications; 4. Before conducting architectural floor plan design, all main and secondary structures should be installed, corrected for verticality, and bolts tightened. Calculate one panel of the entire wall to avoid obstructing the installation of corner edges. A board must be laid horizontally and the verticality of each column checked to ensure it does not exceed the tolerance. 5. Use a spirit level to unify the elevation of the four surrounding pillars, ensuring that the overall installation of the wall is level. The surface of the wall panel should be clean and free of stains. 7. The installation direction of the wall panels must be consistent. The front wall panel is not fixed in place, so the next wall panel cannot be installed. 8. There should be a joint between the wall panels, and each joint should be uniform without different widths. 9. All self tapping screws should be perpendicular to the wall and not inclined. 10. When handling scaffolding, pay attention to protecting the wall panels and avoiding friction. 11. The sunken wall purlins should be supported with wood to make them straight
|
